FR SERIES AMPLIFIERS
|
|
| M2600 SPECS |
|
|
|
M2600
|
||
|
IMPEDANCE |
MAX. POWER @ 1% DISTORTION |
*CONTINUOUS POWER |
|
2 Ohms |
1300 Watts |
1000 Watts |
|
4 Ohms |
850 Watts |
700 Watts |
|
8 Ohms |
500 Watts |
425 Watts |
|
4 Ohms Bridge-Mono |
2600 Watts |
2000 Watts |
|
8 Ohms Bridge-Mono |
1700 Watts |
1400 Watts |
|
GENERAL SPECS |
|
| Rise time | < 4.4 µsec. |
| Voltage Slew Rate | > 60 V/µsec. |
| Current Slew Rate | > 30 A/µsec. @ 2 ohms |
| Gain | 32.7dB (43V/V) |
| Input Sensitivity | 1.23 volts (+4dBu) |
| Input Impedance | 24 kilohms balanced |
| Signal to Noise Ratio | > 107dB below rated power - 700 watts @ 4 ohms |
| Transient Recovery | (20dB overdrive @ 1kHz) < 1 µsec. |
| Turn On Delay | 3 seconds |
| Speaker Protection | Speaker Relay (open at turn-on & off, when DC offset is present, when short detected, or when unit is too hot) |
| Variable Low Cut Filter | 10Hz (off) to 170Hz 2nd Order Bessel 12db/Octave |
| Net Weight | 55 pounds / 25kg |
| Rackmountable Height | 5.2" (13.2 cm) |
| Rackmountable Depth | 15.65" (39.8 cm) |
|
Electronic Crossovers: |
| 4th Order Linkwitz-Riley, switchable @ 60Hz, 90Hz & 120Hz |
| Low pass outputs available to internal subwoofer modes |
| Low pass & high pass outputs switchable to thru jacks |
US Speaker, LLC
