PROFESSIONAL AMPLIFIERS

XTI2 SERIES

Crown XTi Series Amps

XTi 1002 - Item Price: $649.95

XTi 2002 - Item Price: $949.95

XTi 4002 - Item Price: $1,279.95
XTi 6002 - Item Price: $2,549.95
 

XTi 1002

XTi 2002 XTi 4002 XTi 6002
2Ω Stereo (per ch.) 700W 1000W 1600W 3000W
4Ω Stereo (per ch.) 500W 800W 1200W 2100W
8Ω Stereo (per ch.) 275W 475W 650W 1200W
8Ω Bridge-Mono 1000W 1600W 2400W 4200W
4Ω Bridge-Mono 1400W 2000W 3200W 6000W
INTEGRATED PROCESSING

Input EQ

6 parametric filters per channel with adjustable Q, ±15 dB boost/cut. Also adjustable high and low shelving filters. This 8-filter EQ section can be bypassed

Crossover Filters

Highpass and Lowpass per channel. Butterworth 6/12/18/24 dB per octave. Linkwitz-Riley 24/48 dB per Octave. Also includes ± 15 dB bandpass gain and polarity control

Output EQ

8 parametric filters per channel with adjustable Q, ±15 dB boost/cut. This 8-filter EQ section can be bypassed

Delay
For signal alignment of driver; 50 mS of total delay
SubHarmonic Synth
Takes the low-frequency content of the input signal and "synthesizes" a new signal that is the same as the input signal but one octave lower. The new synthesized signal is then mixed with the original signal to create the effect. Users now have control over frequency, gain, and filter type
Peakx™ Plus Limiter
User defeatable limiter that allows users to control Threshold, Attack, and Release times
Presets
50 total presets, 49 of which are user-definable
PERFORMANCE
Sensitivity (for full rated power at 4 ohms) 1.4 Vrms
Frequency Response (at 1 watt, 20 Hz - 20 kHz) +0 dB, –1 dB
Signal-to-Noise Ratio (below rated 1kHz power at 8 ohms) XTi1002/2002/4002: 100 dB (A weighted)
XTi6002: 103 dB (A weighted)
Total Harmonic Distortion (THD) < 0.5%
Damping Factor 20 Hz to 1 kHz > 500
Crosstalk (below rated power) 20 kHz - 1 kHz: > 70 db
Input Impedance (nominal) 20k ohms balanced, 10k ohms unbalanced
Maximum Input Signal +22 dBu typical
AC Line Voltage and Frequency Configurations 100 VAC, 120 VAC, 220-240 VAC 50/60 Hz
AC Line Current
(120 VAC amplifier playing 1/8 power pink noise into 4 ohms per ch)
XTi1002: 6.8A; no more than 38W at idle
XTi2002: 8.3A; no more than 38W at idle
XTi4002: 10.5A; no more than 38W at idle
XTi6002: 15.3A; no more than 180W at idle
Operating Temperature 0°C to 40°C at 95% relative humidity (non-condensing)

CONTROLS

Level Two front-panel rotary level controls, one for each channel
Power Switch On/Off switch applies AC power to the amplifier
Sel/Prev/Next Buttons Three buttons near the LCD screen that are used to access menu items and front panel lockout
LCD Screen Backlit liquid crystal display that shows preset and processing status

INDICATORS

Signal Indicator Green LED, one per channel, illuminates when a very low-level signal is present at input (may be used for troubleshooting cable runs)
–10 Indicator Green LED flashes when output signal exceeds -10 dB below clip
–20 Indicator Green LED flashes when output signal level exceeds -20 dB below clip
Ready Indicator Green LED, one per channel, illuminates when the amplifier is ready to produce audio
Clip Indicator Red LED, one per channel, turns on at the threshold of audible distortion
Temp Indicator Red LED, one per channel, illuminates under excessive temperature conditions
Power Indicator Blue LED illuminates when the amplifier has been turned on and has power

INPUT/OUTPOT CONNECTORS

Input Connectors XLR, one per channel
Link/Out Connector Loop-thru signal from input connector for linking another amplifier, one per channel
Output Connectors Two Neutrik® Speakon® NL4MP output connectors. Channel-1 Speakon® is wired with Ch. 1 and Ch. 2 outputs for use with optional single 4-conductor cable. Two binding post outputs (in parallel with Speakon® connectors)
HiQnet™ USB Connector Type B, connects to HiQnet™ network

CONSTRUCTION

Chassis Steel
Front Panel Cast-aluminum
Cooling Proportional speed fan with front-to-rear airflow
Dimensions XTi 1002/2002/4002: 19" (W) x 3.5" (H) x 12.25" (D)
XTi 6002: 19" (W) x 3.5" (H) x 16.2" (D)
Net Weight XTi 1002/2002/4002: 18.5 lbs (8.4kg)
XTi 6002: 24.0 lbs (10.9kg)
Shipping Weight XTi 1002/2002/4002: 21.5 lbs (9.8kg)
XTi 6002: 30.0 lbs (13.6kg)

US Speaker, LLC